ON Manuals (Industrial)

The NCP1402 is a 200mA, PFM step-up micropower switching regulator from Semiconductor Components Industries. It features an extremely low startup voltage (0.8V), high efficiency (85%), low operating current (30μA), high output voltage accuracy (±2.5%), low converter ripple (typical 30mV), and requires only three external components.

File format: PDF Size:206 KB

MC14099B is an 8-bit addressable latch. Data is entered in serial form when the appropriate latch is addressed (via address pins A0, A1, A2) and write disable is in the low state. For the MC14099B the input is a unidirectional write only port. The data is presented in parallel at the output of the eight latches independently of the state of Write Disable, Write/Read or Chip Enable. A Master Reset capability is available on both parts.

File format: PDF Size:100 KB

This document is the English version of the datasheet for MZP4729A series 3 Watt DO-41 Surmetic®30 Zener Voltage Regulators. This series of Zener diodes have superior electrical performance and can be used in various environments.

File format: PDF Size:126 KB

This document describes a series of 3-watt Zener diodes with excellent operating characteristics and silicon-oxide passivated junctions. The product is protected in an axial-lead, transfer-molded plastic package and offers superior capabilities.

File format: PDF Size:68 KB

This is a complete series of 3 Watt Zener diodes with limits and excellent operating characteristics that reflect the superior capabilities of silicon–oxide passivated junctions. All this in an axial–lead, transfer–molded plastic package that offers protection in all common environmental conditions.

File format: PDF Size:68 KB

The ON Semiconductor 74FST3400 is a 4-bit, 4-port bus exchange switch. The device is CMOS TTL compatible when operating between 4.0 and 5.5 Volts. The device exhibits extremely low RON and adds nearly zero propagation delay. The device adds no noise or ground bounce to the system.

File format: PDF Size:106 KB

This file introduces the characteristics of the LM285/LM385 series micropower two-terminal bandgap voltage regulator diodes. This series products are packaged in a low-cost TO-226 plastic case and are available with an operating current range of 10μA to 20mA, featuring exceptionally low dynamic impedance, low noise and stable operation over time and temperature. Tight voltage tolerances are achieved by on-chip trimming. The large dynamic operating range enables these devices to be used in applications with widely varying supplies with excellent regulation. Extremely low operating current make these devices ideal for micropower circuitry like portable instrumentation, regulators and other analog circuitry where extended battery life is required.

File format: PDF Size:85 KB

This document introduces N-Channel TO-220 and D2PAK packaged semiconductor devices designed for high voltage, high speed switching applications in power supplies, converters, power motor controls, and bridge circuits. It features higher current rating, lower RDS(on), lower capacitances, lower total gate charge, and tighter VSD specifications. Typical applications include switch mode power supplies, PWM motor controls, converters, and bridge circuits.

File format: PDF Size:47 KB

This document describes the NTHD5903T1 chip, which features low RDS(on) for higher efficiency, logic level gate drive, and a miniature ChipFET surface mount package that saves board space. The chip is suitable for power management in portable and battery-powered products, such as cellular and cordless telephones and PCMCIA cards.

File format: PDF Size:60 KB

NTD20N03L27 is an N-channel DPAK power MOSFET with a rated current of 20 amperes and a rated voltage of 30 volts. The device features low on-resistance (Rds(on)), single base, advanced technology. SPICE parameters are available. The diode is characterized for use in bridge circuits. IDSS and VDS(on) are specified at elevated temperatures. High avalanche energy is specified. ESD JEDAC rated HBM Class 1, MM Class A, CDM Class 0. Typical applications include power supplies, inductive loads, PWM motor controls and replacement for MTD20N03L in many applications.

File format: PDF Size:59 KB

The NCP300 and NCP301 series are second generation ultra-low current voltage detectors. These devices are specifically designed for use as reset controllers in portable microprocessor based systems where extended battery life is paramount. Each series features a highly accurate undervoltage detector with hysteresis which prevents erratic system reset operation as the comparator threshold is crossed. The NCP300 series consists of complementary output devices that are available with either an active high or active low reset output. The NCP301 series has an open drain N-Channel output with either an active high or active low reset output. The NCP300 and NCP301 device series are available in the Thin TSOP-5 package with standard undervoltage thresholds. Additional thresholds that range from 0.9 V to 4.9 V in 100 mV steps can be manufactured.

File format: PDF Size:164 KB

This document describes a 6.8-100 pF, 30 volt voltage variable capacitance diode. The product is designed for FM radio and TV tuning, AFC, general frequency control, and tuning applications. It features high Q, controlled and uniform tuning ratio, and standard capacitance tolerance.

File format: PDF Size:81 KB

MMBZ5221ELT1 Series Zener Voltage Regulators, 225 mW SOT−23 Surface Mount. This series of Zener diodes is offered in the convenient, surface mount plastic SOT−23 package. These devices are designed to provide voltage regulation with minimum space requirement. They are well suited for applications such as cellular phones, hand held portables, and high density PC boards.

File format: PDF Size:74 KB

This document describes the MC7800, MC7800A, and NCV7805, three models of 1.0A positive voltage regulators. These voltage regulators are monolithic integrated circuits designed for a wide range of applications, including local and on-card voltage regulation. They feature internal current limiting, thermal shutdown, and safe-area compensation. With sufficient heat sinking, they can provide output currents exceeding 1.0A. While primarily designed as fixed voltage regulators, these devices can be used with external components to obtain adjustable voltages and currents.

File format: PDF Size:234 KB

MC10LVEP16, MC100LVEP16 2.5V / 3.3V�ECL Differential Receiver/Driver is functionally equivalent to the EL16, EP16 and LVEL16 devices, but with output transition times significantly faster than the EL16 and LVEL16, the LVEP16 is ideally suited for interfacing with high frequency and low voltage (2.5 V) sources

File format: PDF Size:129 KB

MC10EP05/D is an 3.3V / 5V�ECL 2−Input Differential AND/NAND device produced by ON Semiconductor, with a typical propagation delay of 220 ps, a typical maximum frequency of >3 GHz, a PECL mode operating range of VCC = 3.0 V to 5.5 V and VEE = 0 V, a NECL mode operating range of VCC = 0 V and VEE = −3.0 V to −5.5 V, an open input default state, a safety clamp on the inputs, a Q output that will default to low voltage when the inputs are open or at VEE

File format: PDF Size:95 KB

This document introduces a Zener voltage regulator that uses a convenient surface mount plastic SOD−123 package. The product has a rated power of 500mW, a wide range of reverse Zener voltages, and is suitable for high-density applications.

File format: PDF Size:77 KB

This product is a four-channel common anode transient voltage suppressor for ESD protection. It has four unidirectional configurations and high power output. This product has low leakage and high ESD rating.

File format: PDF Size:66 KB

The MC100EP016A is a high-speed synchronous, presettable, cascadeable 8-bit binary counter.

File format: PDF Size:131 KB

NTR1P02LT1 is a P-channel MOSFET from Semiconductor Components Industries, LLC with a rated voltage of -20 V and a rated current of -1.3 A. It is housed in a SOT-23 package and features low RDS(on) for improved efficiency and extended battery life.

File format: PDF Size:48 KB