intersil Manuals (Industrial)

intersil ISL6440 handbook

The ISL6440 is a high performance, dual output PWM controller that can convert DC input power from wall adapters, batteries or network backplanes to system power voltages required for a variety of applications. Each output is adjustable down to 0.8V. The two PWMs are 180° out of phase synchronized, reducing the input current and ripple voltage RMS.

File format: PDF Size:527 KB

intersil ISL6410 ISL6410A handbook

The ISL6410 and ISL6410A are synchronous current-mode PWM regulators designed to provide a total DC-DC solution for microcontrollers, microprocessors, CPLDs, FPGAs, core processors/BBP/MAC, and ASICs. The ISL6410 should be selected for applications using 3.3V ±10% as an input voltage and the ISL6410A in applications requiring 5.0V ±10%. These synchronous current mode PWM regulators have integrated N- and P-Channel power MOSFETs and provide pre-set pin programmable outputs. Synchronous rectification with internal MOSFETs is used to achieve higher efficiency and a reduced external component count. The operating frequency of 750kHz typical allows the use of small inductor and capacitor values. The device can be synchronized to an external clock signal in the range of 500kHz to 1MHz. A power good signal “PG” is generated when the output voltage falls outside the regulation limits. Other features include overcurrent protection and thermal overload shutdown. The ISL6410 and ISL6410A are available in an MSOP 10 lead package.

File format: PDF Size:385 KB

intersil ISL6123 ISL6124 ISL6125 ISL6126 ISL6127 ISL6128 handbook

The ISL6123, ISL6124, ISL6125, ISL6126, ISL6127, ISL6128 are a four-channel power supply sequencer with supply monitoring, fault protection and a "sequence completed" signal (RESET#).

File format: PDF Size:560 KB

intersil ISL43L710 ISL43L711 ISL43L712 handbook

ISL43L710, ISL43L711, ISL43L712 Ultra Low ON-Resistance, Single Supply, Differential SPST Analog Switches

File format: PDF Size:309 KB

intersil ICL7112 12-Bit High-Speed CMOS P-Compatible A/D Converter handbook

The ICL7112 is a monolithic 12-bit resolution, fast successive approximation A/D converter. It uses thin film resistors and CMOS circuitry combined with an on-chip PROM calibration table to achieve 12-bit linearity without laser trimming. Special design techniques used in the DAC and comparator result in high speed operation, while the fully static silicon-gate CMOS circuitry keeps the power dissipation very low. Microprocessor bus interfacing is eased by the use of standard memory WRite and ReaD cycle timing and control signals, combined with Chip Select and Address pins. The digital output pins are byte-organized and three-state gated for bus interface to 8-bit and 16-bit systems. The lCL7112 provides separate Analog and Digital grounds for increased system accuracy. Operating with ±5V supplies, the lCL7112 accepts 0V to +10V input with a -10V reference or 0V to -10V input with a +10V reference.

File format: PDF Size:593 KB

intersil HI5905N/QML Data Sheet

The HI5905N/QML is a monolithic, 14-bit, 5MSPS Analog- to-Digital Converter fabricated in an advanced BiCMOS process. It is designed for high speed, high resolution applications where wide bandwidth, low power consumption and excellent SINAD performance are essential.

File format: PDF Size:93 KB

intersil HI-5042 HI-5043 HI-5047 HI-5049 HI-5051 Data Sheet

This datasheet introduces the features and characteristics of the HI-5042, HI-5043, HI-5047, HI-5049, HI-5051 CMOS Analog Switches series devices. This series devices offer low resistance switching performance for analog voltages up to the supply rails and for signal currents up to 80mA.

File format: PDF Size:406 KB

intersil HCTS299MS Radiation Hardened 8-Bit Universal Shift Register; Three-State handbook

HCTS299MS is an 8-bit universal shift register with three-state function produced by Intersil. The product uses a 3-micron radiation-hardened CMOS SOS process, with a total dose of 200K RAD (Si), an SEP effective LET no upsets of >100 MEV-cm2/mg, a < 2 x 10-9 errors/bit day (typical) single event upset (SEU) immunity, a >1 x 1012 RAD (Si)/s dose rate survival capability, and a >1010 RAD (Si)/s 20ns pulse dose rate upset. The product is free from latch-up under any conditions and supports 15 LSTTL load bus driver outputs.

File format: PDF Size:122 KB

intersil HUF76139P3 HUF76139S3S handbook

HUF76139P3/S3S is an N-Channel logic level power MOSFET manufactured by Intersil with 75A, 30V, 0.0075 Ohm performance, suitable for applications requiring high power efficiency, such as switching regulators, switching converters, motor drivers, relay drivers, low- voltage bus switches and power management in portable and battery-operated products

File format: PDF Size:128 KB

intersil HUF76137P3 HUF76137S3S handbook

These N-Channel power MOSFETs are manufactured using the innovative UltraFET™ process. This advanced process technology achieves the lowest possible on-resistance per silicon area, resulting in outstanding performance. This device is capable of withstanding high energy in the avalanche mode and the diode exhibits very low reverse recovery time and stored charge. It was designed for use in applications where power efficiency is important, such as switching regulators, switching converters, motor drivers, relay drivers, low- voltage bus switches, and power management in portable and battery-operated products. Formerly developmental type TA76137.

File format: PDF Size:115 KB

intersil HUF76132SK8 handbook

This product is a N-channel power MOSFET manufactured using the innovative UltraFET™ process. It has the lowest possible on-resistance per silicon area, resulting in outstanding performance. It is capable of withstanding high energy in the avalanche mode and the diode exhibits very low reverse recovery time and stored charge. It was designed for use in applications where power efficiency is important, such as switching regulators, switching converters, motor drivers, relay drivers, low-voltage bus switches, and power management in portable and battery-operated products.

File format: PDF Size:131 KB

intersil HUF76132P3 HUF76132S3S handbook

This document describes the features and characteristics of HUF76132P3 and HUF76132S3S N-Channel power MOSFETs. These products are manufactured using the innovative UltraFET™ process, achieving low on-resistance, high energy tolerance in avalanche mode, and low reverse recovery time. They are suitable for applications where power efficiency is important, such as switching regulators, switching converters, motor drivers, relay drivers, low-voltage bus switches, and power management in portable and battery-operated products.

File format: PDF Size:117 KB

intersil HUF76131SK8 handbook

This document is the technical manual of HUF76131SK8 10A, 30V, 0.013 Ohm, N-Channel, Logic Level UltraFET Power MOSFET, introducing the features and characteristics of this product.

File format: PDF Size:201 KB

intersil HUF76129P3 HUF76129S3S handbook

This is an N-Channel power MOSFET, manufactured using the innovative UltraFET™ process, with the lowest possible on-resistance per silicon area, resulting in outstanding performance. It is capable of withstanding high energy in the avalanche mode and the diode exhibits very low reverse recovery time and stored charge. It was designed for use in applications where power efficiency is important, such as switching regulators, switching converters, motor drivers, relay drivers, low- voltage bus switches, and power management in portable and battery-operated products.

File format: PDF Size:116 KB

intersil HUF76129D3 HUF76129D3S handbook

File format: PDF Size:0 KB

intersil HUF76121SK8 handbook

HUF76121SK8 is an N-channel power MOSFET manufactured by Intersil using the innovative UltraFET™ process. This advanced process technology achieves the lowest possible on-resistance per silicon area, resulting in outstanding performance. This device is capable of withstanding high energy in the avalanche mode and the diode exhibits very low reverse recovery time and stored charge. It was designed for use in applications where power efficiency is important, such as switching regulators, switching converters, motor drivers, relay drivers, low-voltage bus switches, and power management in portable and battery- operated products. Formerly developmental type TA76121.

File format: PDF Size:131 KB

intersil HUF76121P3 HUF76121S3S handbook

This document describes the features and characteristics of the HUF76121P3 and HUF76121S3S products. These products are N-channel power MOSFETs manufactured using the innovative UltraFET™ process. They have high energy withstand capability in avalanche mode, and the diode exhibits very low reverse recovery time and stored charge. They are designed for applications where power efficiency is important, such as switching regulators, switching converters, motor drivers, relay drivers, low-voltage bus switches, and power management in portable and battery-operated products.

File format: PDF Size:116 KB

intersil HUF76105DK8 handbook

HUF76105DK8 is a low on-resistance (RDS(ON) = 0.050 Ω) N-channel power MOSFET from Intersil Corporation. It has a working voltage of 30V and a maximum current of 5A. This device is suitable for applications that require high power efficiency, such as switching regulators, switching converters, motor drivers, relay drivers, low-voltage bus switches and power management in portable and battery operated products.

File format: PDF Size:181 KB

intersil HUF76013P3 HUF76013D3S handbook

This document introduces HUF76013P3 and HUF76013D3S, two 20A, 20V, 0.022 Ohm N-channel logic level power MOSFETs. These devices are optimized for switching when used as the upper switch in synchronous buck applications. The low gate charge and low input capacitance result in lower driver and switching losses, thereby increasing the overall system efficiency.

File format: PDF Size:170 KB

Brands



Products